D.11 Asynchronous Task Control
This clause introduces a language-defined package to do asynchronous suspend/resume on tasks. It uses a conceptual held priority value to represent the task's held state.
The following language-defined library package exists:
with Ada.Task_Identification; package Ada.Asynchronous_Task_Control is procedure Hold(T : in Ada.Task_Identification.Task_ID); procedure Continue(T : in Ada.Task_Identification.Task_ID); function Is_Held(T : Ada.Task_Identification.Task_ID) return Boolean; end Ada.Asynchronous_Task_Control;
After the Hold operation has been applied to a task, the task becomes held. For each processor there is a conceptual idle task, which is always ready. The base priority of the idle task is below System.Any_Priority'First. The held priority is a constant of the type integer whose value is below the base priority of the idle task.
The Hold operation sets the state of T to held. For a held task: the task's own base priority does not constitute an inheritance source (see D.1), and the value of the held priority is defined to be such a source instead.
The Continue operation resets the state of T to not-held; T's active priority is then reevaluated as described in D.1. This time, T's base priority is taken into account.
The Is_Held function returns True if and only if T is in the held state.
As part of these operations, a check is made that the task identified by T is not terminated. Tasking_Error is raised if the check fails. Program_Error is raised if the value of T is Null_Task_ID.
If any operation in this package is called with a parameter T that specifies a task object that no longer exists, the execution of the program is erroneous.
An implementation need not support Asynchronous_Task_Control if it is infeasible to support it in the target environment.
33 It is a consequence of the priority rules that held tasks cannot be dispatched on any processor in a partition (unless they are inheriting priorities) since their priorities are defined to be below the priority of any idle task.
34 The effect of calling Get_Priority and Set_Priority on a Held task is the same as on any other task.
35 Calling Hold on a held task or Continue on a non-held task has no effect.
36 The rules affecting queuing are derived from the above rules, in addition to the normal priority rules:
- When a held task is on the ready queue, its priority is so low as to never reach the top of the queue as long as there are other tasks on that queue.
- If a task is executing in a protected action, inside a rendezvous, or is inheriting priorities from other sources (e.g. when activated), it continues to execute until it is no longer executing the corresponding construct.
- If a task becomes held while waiting (as a caller) for a rendezvous to complete, the active priority of the accepting task is not affected.
- If a task becomes held while waiting in a selective_accept, and an entry call is issued to one of the open entries, the corresponding accept_alternative executes. When the rendezvous completes, the active priority of the accepting task is lowered to the held priority (unless it is still inheriting from other sources), and the task does not execute until another Continue.
- The same holds if the held task is the only task on a protected entry queue whose barrier becomes open. The corresponding entry body executes.
Copyright © 1992,1993,1994,1995 Intermetrics, Inc.
Copyright © 2000 The MITRE Corporation, Inc. Ada Reference Manual